NAPA AutoCare of Nashville

The brake rotor, or disc, is attached to your wheel. The brake pads rub on the rotor to slow your vehicle.

Rotors can warp, crack or become misaligned. They can also be damaged by worn out brake pads that scratch grooves into the surface. These conditions result in less contact surface for the brake pads, leaving you with reduced braking power.

Over time and miles, rotors can also wear down below safe specifications. It is critical for Mount Juliet car owners to know that simply replacing brake pads on a wheel with a bad rotor will not solve the issue. Depending on their condition, rotors may be resurfaced or replaced.

Brake noise or a pulsation in the brake pedal are signs of potential brake troubles that should be addressed right away. If you have any brake concerns, please have your friendly Conder’s Automotive tech complete a thorough analysis.

Give us a call

Conder’s Automotive
615-758-1515
441 East Division Street
Mount Juliet, Tennessee 37209

Richard Petty once told AutoNetTV, “You’ve gotta have good brakes. If you’ve got good brakes you can keep yourself out of a lotta trouble.”

That’s why a regular brake inspection is on every Mount Juliet car’s maintenance schedule. An inspection at Conder’s Automotive will check your brake system and let you know if there are any problems.

Of course, if you’re having trouble with your brakes, get your car into Conder’s Automotive right away. Here are some symptoms to watch for:

• Low or spongy brake pedal
• Hard brake pedal
• A brake warning light that stays on
• Constantly squealing or grinding brakes
• Vibrations or clunking sounds when you apply your brakes

If you are experiencing any of these, it’s time to get your brakes checked.

There are two types of brakes: disc and drum. Disc brakes have a rotor that’s attached to the axle. Calipers straddle the rotor, kind of like the brakes on a bicycle.

Drum brakes are more common on back wheels. Both types have pads or shoes that press against the brakes and slow the vehicle. Brake pads and shoes are made out of very tough material to withstand the heat and force generated when stopping your car. Eventually, they wear out with use, and become too thin and need to be replaced.

If the brake pads wear away completely, you can damage the rotors. The calipers can grind grooves in the rotor. Then the rotor must either be resurfaced or replaced. That’s not only expensive, but also dangerous because your vehicle won’t stop as quickly. Sometimes rotors warp or crack and must be replaced.

Brake service will also include a check of your brake fluid. When the brakes are applied, the pressure in the fluid actives the brake pads or shoes. Not enough fluid means not enough pressure to brake properly. Also, water builds up in the brake fluid over time, which leads to corrosion, leaks and brake damage, and with hard use, the brakes could severely fade or even fail. You should change the brake fluid when your manufacturer recommends to avoid these problems.

There are different grades of brake pads; good, better and best. Higher grades cost more, but give better braking performance and smoother operation. It’s OK to upgrade your brake pads. But, never use a grade that’s lower than what the manufacturer recommends.

So, be sure to properly maintain your brakes, because it’s a lot cheaper than paying the body shop after an accident.

Come in to Conder’s Automotive for an brake inspection before damage occurs. You can call ahead for an appointment by calling 615-758-1515.